Connexion rapide:  

Forum: VirtualDJ Technical Support

Sujet DYNACORD CMS 600-3 Issues with Sound Drops during use

Ce topic est ancien et peut contenir des informations obselètes ou incorrectes.

I have purchased a new desk the Dynacord CMS 600-3 and last night was its first time use. I have a Pro licence for VDJ and it picked up the desk straight away without any customisation required. I downloaded the latest ASIO drivers from Dynacord website also.

After about 15 minutes i noticed that the sound stopped for about half a second then came back on. I also noticed this a further 4 times through the night. Just wondering if you could point me in to the correct direction to resolve this issue please. There was no distortion on the audio just a straight drop then back on.
 

Posté Fri 19 Apr 19 @ 10:13 am
locodogPRO InfinityModeratorMember since 2013
 

Posté Fri 19 Apr 19 @ 10:26 am
djdadPRO InfinityDevelopment ManagerMember since 2005
Does it work without the ASIO driver , so just with WASAPI ?
If not , open the ASIO settings and see the Latency value. You may have to increase if too low.
 

Posté Fri 19 Apr 19 @ 10:28 am
Latency is automatic in options 256
 

Posté Fri 19 Apr 19 @ 11:06 am
djdadPRO InfinityDevelopment ManagerMember since 2005
And you should leave it at Automatic, if you mean the VDJ Options and use ASIO. You should open the unit's ASIO Control panel of the sound card and adjust the latency from there.
256 is quite low, 512 is OK, 1024 is safe but not good if you scratch
 

Posté Sat 20 Apr 19 @ 3:20 am


(Les anciens sujets et forums sont automatiquement fermés)