Mr_T
- I can´t use the Display with Deck 3 and Deck 4 with the Nativ mapping.
- Loop Buttons lighting up with different Buttons and function...
- can´t use Filter Touch Button on the Filter Screw/Poti
- Hardware: There is no Sampler Volume Fader -_- but this is a misstake of Numark
- Loop Buttons lighting up with different Buttons and function...
- can´t use Filter Touch Button on the Filter Screw/Poti
- Hardware: There is no Sampler Volume Fader -_- but this is a misstake of Numark
Posté Thu 19 Mar 15 @ 2:08 am
djdad
Are you sure you re running a build greater than 2174 ..? http://www.virtualdj.com/forums/199180/Hardware_Technical_Support/Numark_NV_-_Version_8_Support.html
Sampler. Volume can be controled too . Take a look at the manual
Sampler. Volume can be controled too . Take a look at the manual
Posté Fri 20 Mar 15 @ 7:57 am
Mr_T
Version 2177
Posté Tue 24 Mar 15 @ 9:55 am
djdad
Sorry, cant reproduce any of the above.
Can you verify that the 3 units are assigned as followed ?
Numark NV Display Left ->Assigned : Automatic (1.3)
Numark NV Display Right ->Assigned : Automatic (2,4)
Numark NV ->Assigned : Automatic (1,2,3,4)
Btw, you can adjust the Sampler Master Volume, if you switch to the SAMPLER mode and use the BEATS knob while the SAMPLER mode button is pressed.
Can you verify that the 3 units are assigned as followed ?
Numark NV Display Left ->Assigned : Automatic (1.3)
Numark NV Display Right ->Assigned : Automatic (2,4)
Numark NV ->Assigned : Automatic (1,2,3,4)
Btw, you can adjust the Sampler Master Volume, if you switch to the SAMPLER mode and use the BEATS knob while the SAMPLER mode button is pressed.
Posté Tue 24 Mar 15 @ 5:11 pm
Mr_T
I dont´t have this controller, i was in Musicstore Cologne (Germany) to check it.
The Reseller ask me, because the mapping with Virtual DJ
The Reseller ask me, because the mapping with Virtual DJ
Posté Wed 25 Mar 15 @ 10:50 am