Hey all, I'm not entirely sure the syntax used if I'm trying to map key changes to an endless knob. I would like to be able to cycle up and down through individual Key changes, but thus far I've only been able to achieve this in one direction, or more as an on/off style switch. I feel like a Param command isn't correct for changing the keys, but at this point I'm stumped. Any suggestions? Thanks in advance.
Posté Tue 08 Dec 15 @ 4:56 am
PhantomDeejay
Try param_smaller 0 ? Key -1 : key +1
However just typing "key" should also work since the value of the encoder is passed as an implicit parameter
However just typing "key" should also work since the value of the encoder is passed as an implicit parameter
Posté Tue 08 Dec 15 @ 8:12 pm
Lvx11378
Corbow6 wrote :
Hey all, I'm not entirely sure the syntax used if I'm trying to map key changes to an endless knob. I would like to be able to cycle up and down through individual Key changes, but thus far I've only been able to achieve this in one direction, or more as an on/off style switch. I feel like a Param command isn't correct for changing the keys, but at this point I'm stumped. Any suggestions? Thanks in advance.
Updated: Okay, stumbled around and figured out this script:
param_greater 0 ? key_move +0.5 : key_move -0.5
now I'm stuck trying to add shift modifiers to allow control of the effects with more complex instructions, and I'm a bit stuck with order of operations I think.
I tried,
var "shift" ? effect 2 select : param_greater 0 ? key_move +0.5 : key_move -0.5
It didn't work for the key_move at this point.
Posté Tue 08 Dec 15 @ 8:16 pm
PhantomDeejay
Tell us what you want to do. Then we can answer and analyse the script so that you start learning.
Posté Tue 08 Dec 15 @ 8:18 pm
Lvx11378
Post updated.
Posté Tue 08 Dec 15 @ 8:22 pm
Hey, OP here. Lvx is just my buddy who was posting our problem from his setup.
Posté Tue 08 Dec 15 @ 10:19 pm