Hardware Manuals


Pioneer DJ - XDJ-XZ - Disposition  

MASTER & USB SOURCES




KEY

ACTION

57 MASTER LEVEL
Use this knob to adjust the level of the Master Output (connection at the rear panel)
58 MASTER VU METER
This series of leds indicate the level of the Master Output
59 MASTER CUE
USe this button to send the signal of the Master Output to the Headphones channel. Use the Headphones Cue/Master mix knob to blend this signal with the signals of the Mixer Channels that have their CUE buttons enabled
60 MASTER EQ
Use these knobs to adjust the High, Mid and Low frequencies of the Master Output signal
61 BOOTH LEVEL
Use this knob to adjust the level of the Booth Output (connection at the rear panel)
62 USB 1
Use this socket to connect a USB Flash Drive. When connected, use the USB 1 button at the left side of the Display to Browse through its content. This source is not used within VirtualDJ.
Hold down the STOP button below this socket, until the led turns off, to stop reading its content and eject the Media. Do not disconnect the USB drive while its led is on
63 USB 2
Use this socket to connect a USB Flash Drive. When connected, use the USB 2 button at the left side of the Display to Browse through its content. This source is not used within VirtualDJ.
Hold down the STOP button below this socket, until the led turns off, to stop reading its content and eject the Media. Do not disconnect the USB drive while its led is on.
This USB connection can be used to record your mix, including any External Source and Microphones
64 MASTER REC
Press this button to start/stop recording your mix in the USB 2 Drive. The recorded tracks are stored in a PIONEER DJ REC folder in WAV format
65 TRACK MARK
Use this button to split the recording and continue as additional track.


Navigateur & Affichage