1 CROSSFADERBlends audio between left and right mixer channels2 VOLUMEAdjust the Volume of each mixer channel.3 * CUESelect which Chanel/Deck will be sent to Headphones output for pre-listening. Press both buttons simultaneously to send both Decks to Headphones4 FX ON/LOCKEnable/disable the armed Effects on Left/Right Deck. Move paddle to upper position to lock (toggle) or to lower position (and hold) for temporary triggering5 FX1-FX6 ARMSelect the Effect Slots 1 to 6 you wish to arm/prepare and enable/disable using the FX ON paddles. The selection of the Effects in Slots 1 to 6 are done from VirtualDJ GUI. It is advised to have the 6FX Slots panel visible6 FX TAPNo function (Not assigned)7 FX DEPTHAdjust the 1st Parameter (usually Dry/Wet) of the Effects of all 6 FX Slots in both Left/Right Decks simultaneously8 FX BEATSAdjust the Beats Parameter of the Effects of all 6 FX Slots in both Left/Right Decks simultaneously. Push to set Beats Effect Parameter to 1 beat9 LP/HP FILTERApply a Low/High-pass Filter to left/right mixer channel. When centered, no Filter is applied.10 EQAdjust the low (bass), mid (middle) and high (treble) frequencies of left/right mixer channel. Stems Equalizer modes are fully offered See Modern Equalizer11 LEVELAdjusts the pre-fader audio level (gain) of left/right mixer channel.12 SOURCE SELECTSelect the input source of Left/Right mixer channel. Put the switchers to USB A or USB B position for sending Left/Right VirtualDJ Deck to Left/Right mixer channels. Set to LINE to route the audio signal of the Auxiliary LINE inputs(connections at the rear panel) to Left/right mixer Channels.VirtualDJ Decks will be muted in this case. See further details in Advanced Setup13 * MAIN LEVELAdjusts the volume of the Master output of the device (connection at the rear panel).14 * BOOTH LEVELAdjusts the volume of the Booth output of the device (connection at the rear panel).
* Please note that these controls are hardware operated, but their movement/positions will be visible in VirtualDJ GUI.
