Se Connecter:     

Forum: Old versions

Sujet: Timecode Help (Pics included)

Ce topic est ancien et peut contenir des informations obselètes ou incorrectes.

I used to use the RMX alone and recently upgraded my setup to get into turntablism. I am needing some help because I am not sure if everything is the way it should be. Thanks for taking a look...

My setup
Serato CV02 Side B
Technics SL1210M5G
Shure M44-7 (3 grams of tracking weight)
Hercules RMX (switches to phono)
Pioneer DJM-909

RMX ASIO buffer


Timecode Signals L and R


Left Debug


Right Debug


Performance Tab


PC Specs








Every 5-10 seconds the Quality (#s just below the timecode signal) drops to 30% for just a split second and I think that leads to the speed indicator (numbers top right of timecode signal) fluctuating +/- 1.0

This makes the song/videos play inaccurately. It almost sounds like I am pitch bending the songs/videos. Is there anything in my set up that I may have overlooked or any suggested hardware that I could swap out? Any help is appreciated.
 
Posté Thu 05 Aug 10 @ 12:43 am
Bump
 
Start by playing around with the ASIO buffer size. Sometimes a step or 2 can make a big difference.
 
And adjust the silence knob by double clicking on it
 


Ignore my pitch sensitivity settings, but check all the boxes on your system that are checked.







Michael
 
Thanks for the replies.

I have done everything suggested here and it has made some improvement. I have recently switched back to CV02 Side A, along with your suggestions and everything is woking 99.9%.

Thanks again!!
 


(Les anciens sujets et forums sont automatiquement fermés)