Se Connecter:     

Forum: General Discussion

Sujet: Using hercules mk2 with timecode - Page: 2

Ce topic est ancien et peut contenir des informations obselètes ou incorrectes.

i have an audigy... how will make it work in asio mode???
 
Set the Audigy in asio mode (Soundblaster control pannel)

Then use asio soundcard setup inside VDJ (advanced setup, or timecode setup)
 
Thanks Timmyg1978 I just tried it and I've realized that lacks the loop button next to cue.

@caslor
what audigy card you have? mine is audigy2 zs platinum and for tcvs use work perfect.
 
I don't understand it, what is hercules mk2 with timecode ?
 
@japsss,
look for more information here and here
Ewout
 
I tested the 2 x axis 9 + external mixer and herc mk2 for about 2 hours yesterday, and it yielded satisfactory results. Most of the problems I had were the same problems I noticed from the initial setup before I even used timecode. Overall I would say it is good. The scratching is nice, and good enough for my style of scratching, uzi gives digital sound (as was said by others, but I dont often do it anyway). There has been the odd pop or skip but as I said, this is not new. The response between software and hardware is quite good.

The cues do need to be addressed however. I find sometimes it works very good and then another time, the cue point is lost or moved a bit. I hope this is corrected in v4 and am looking forward to it.

That being said, I think I can live with it. I did two gigs over the weekend but did not use the timecode at either of them. I will play this weekend and I think I will test it live then, after a few more hours of dry testing.

Bless
 


(Les anciens sujets et forums sont automatiquement fermés)