Microphone Inputs

The Pioneer XDJ-XZ offers 2 Microphone Inputs (connections at the rear panel) and separate controls at the top panel

KEY

ACTION

51 MIC 1/2 ON-OFF

Set this switcher to OFF position to prevent audio signal from the Microphone Inputs (connections at the rear panel) from output. Set the switcher to ON position to allow audio signal from the Microphone Inputs and route to the Master Output

52 MIC 1/2 TALKOVER

When enabled (led lit) the Output of all Mixer Channels will be automatically reduced when signal is detected from any of the Microphone Inputs.

53 MIC 1/2 LEVEL

Use the top/bottom knob to adjust the level of the Microphone Inputs 1/2 respectively

54 MIC 1/2 EQ

Use the top/bottom HI, MID, LOW knobs to adjust the frequencies of the Microphone Inputs signals 1/2 respectively

55 FEEDBACK REDUCER MODE

Select the Microphone Feedback Reducer mode for both the Microphone Inputs

56 FEEDBACK REDUCER ON

Enable/disable the Microphone Feedback Reducer for both the Microphone Inputs

Note that the Microphone Inputs are not part of the USB Audio Interface, thus they cant be included to the Audio Setup of VirtualDJ, and the MIC Controls of the VirtualDJ GUI will not control these inputs (or vice versa), however both audio signals will be recorded along with your mix.