Hardware Manuals


Rane - Seventy - Disposition  

MIXER , EQUALIZER & OTHER IN/OUT CONTROLS





KEY

ACTION

1 CROSSFADER
Blends audio between left and right mixer channels
2 VOLUME
Adjust the Volume of each mixer channel.
3 CUE CROSSFADER
Blend the pre-fader audio signal from Left and Right mixer channels to the Headphones Output. When set to far left, only the Left channel will be heard in Headphones and when set to far right, only the Right channel will be heard to Headphones
4 CUE MIX
Blends the audio that's being sent on the headphones channel between the headphones signal (far left) and the master output signal (far right).
5 CUE LEVEL
Adjusts the volume of the headphones channel.
6 EQ LOW
Adjust the low (bass) frequencies of left/right mixer channel.
7 EQ MID
Adjust the mid (middle) frequencies of left/right mixer channel.
8 EQ HIGH
Adjust the high (treble) frequencies of left/right mixer channel.
9 LP/HP FILTER
Apply a Low/High-pass Filter to left/right mixer channel. When centered, no Filter is applied.
10 LEVEL
Adjusts the audio level (gain) of left/right mixer channel.
11 SOURCE SELECT
Select the input source of Left/Right mixer channel. Put the switchers to USB A or USB B position for sending Left/Right VirtualDJ Deck to Left/Right mixer channels.
12 MAIN LEVEL
Adjusts the volume of the Master output of the device (connection at the rear panel).
13 BOOTH LEVEL
Adjusts the volume of the Booth output of the device (connection at the rear panel).
14 SESSION IN
Adjusts the volume of the incoming signal on "Session" input on the rear panel of the device.
15 SESSION OUT
Adjusts the volume of the "Session" output (connection at the rear panel of the device).
16 SESSION CUE
When enabled, sends the signal of the "Session" input to the headphones channel for pre-listening..
17 MIC LEVEL
Adjust the volume of the Microphone 1 input (connection at the rear panel of the device)
18 MIC TONE
Adjust the tone (single band equalizer) of the Microphone 1 input (connection at the rear panel of the device)
19 MIC ON
Turn on/off the signal of the Microphone 1 input (connection at the rear panel of the device)
20 MIC ECHO
Applies an Echo effect on the Microphone 1 input


Please note that all these operations are hardware operated, but the movement of some of them will be visible in VirtualDJ GUI.
Effets