Hardware Manuals


Pioneer DJ - OPUS-QUAD - Disposition  

FRONT & REAR PANELS





  1. MIC 2 CONNECTOR Connect your Mic. Both TRS and XLR connection plugs are supported.

  2. MIC 2 CONTROL. Turn ON and OFF the MIC2 Input of the OPUS-QUAD or enable the auto Talk Over.

  3. MIC 2 VOLUME. Adjust the Volume Level of MIC2 Input of the OPUS-QUAD.

  4. MIC 2 LOW EQ. Adjust the Low frequencies of MIC2 Input of the OPUS-QUAD.

  5. MIC 2 MID EQ. Adjust the Middle frequencies of MIC2 Input of the OPUS-QUAD.

  6. MIC 2 HI EQ. Adjust the High frequencies of MIC2 Input of the OPUS-QUAD.

  7. HEADPHONES SOCKET. Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.

  8. USB 3. Use this socket to connect a USB Flash Drive. If you're using a USB cable, please make sure that it's no longer than 2m long. This source is not used within VirtualDJ.

  9. USB (TYPE C) CONNECTOR. Use a USB type C cable to connect OPUS-QUAD with your computer.

  10. LAN (LINK EXPORT) CONNECTOR. Use this port to connect OPUS-QUAD with a router in order to use LINK EXPORT abilities. This connection is not used by VirtualDJ.

  11. MASTER OUT2. Master signal output connectors (RCA – Unbalanced). Use it to connect with another mixer, or consumer grade amplifier.

  12. MASTER OUT1. Master signal output connectors (XLR – Balanced). Use this to connect on your pro grade amplifier or self-powered speakers.

  13. ZONE OUT. Zone signal output connectors (XLR – Balanced). Use this to connect on a different set of pro grade amplifiers or self-powered speakers that require separate control and/or separate music output (please refer to the OPUS-QUAD manual on how to assign a different audio output than Master on ZONE output).

  14. BOOTH OUT. Booth signal output (TRS – Balanced). Use this to connect your booth speakers, or an amp that needs different sound output level than master output.

  15. GND SCREW. Use it to screw your GND (ground) cable from turntables that provide it in order to eliminate ground static noise.

  16. CH4 INPUT. Connect an analog source on CH4 of the OPUS-QUAD mixer. You can connect a turntable or a CD-Player.

  17. CH3 INPUT. Connect an analog source on CH3 of the OPUS-QUAD mixer. You can connect a turntable or a CD-Player.

  18. MIC 1 CONNECTOR. Connect your Mic. Both TRS and XLR connection plugs are supported.

  19. POWER SWITCH. Turns on/off the power on the device. Please turn on the device only after doing and securing all connections on the back.

  20. AC INPUT. Connect a standard IEC power supply cable.