Hardware Manuals


Pioneer DJ - DDJ-REV5 - Disposition  

FRONT PANEL






  1. MIC OFF/ON/TALKOVER. : Turn the Microphone input On/Off. If set to TALKOVER, when sound of -10dB or more is input to the microphone, the volume other than the microphone channel is attenuated by -18dB. You can change the attenuation level of Mic Talkover in Utilities mode. See Advanced Setup

  2. MIC 1 / MIC 2 LEVEL. : Adjust the output level of Microphone Inputs 1 and 2 (connections at the rear panel)

  3. MIC EQ : Adjusts the volume of both the Mic 1 and 2 inputs as following
    HI : -12 dB to +12 dB (10 kHZ)
    LOW : -12 dB to +12 dB (100 kHZ)

  4. CROSSFADER REVERSE : When turned on, the Crossfader will operate in reverse

  5. CROSSFADER CURVE : Sets the crossfader curve from a Gradual/Linear slope (minimum) to a Scratch/Cut slope (maximum)

  6. HEADPHONES CONNECTOR: Connect your headphones to these terminals using a stereo 3.5mm or 6.35mm phone plug.

  7. HEADPHONES LEVEL. Adjust the volume of the Headphones output.
    This is a hardware function, does not control the Headphones volume of VirtualDJ or vice versa.

  8. HEADPHONES MIX. Adjust how the Channels and the Master Output will blend at the Headphones output. This is a hardware function, does not control the Headphones Cue/Mix of VirtualDJ or vice versa.

  9. AUX OFF/LINE/PORTABLE : No signal from the AUX input when set to OFF. Set to LINE to route the sound from the auxiliary device connected at the rear panel to the Master Output. Set to PORTABLE when connecting a mobile device.

  10. AUX LEVEL : Adjust the volume of the AUX input sound